Need help?Do you have a question about the Pioneer VSA-E07 and is the answer not in the manual?
Amplifier Section| continuous power output (stereo mode) | 130 W + 130 W (DIN 1 kHz, THD 1 %, 6Ω) |
|---|---|
| continuous power output (surround mode) | 130 W + 130 W / 130 W center (DIN 1 kHz, THD 1 %, 6Ω) |
| rated power output | 100 W + 100 W (20 Hz-20 kHz, THD 0.09 %, 8Ω) |
| input sensitivity/impedance (phono mm) | 4.7 mV/47 kΩ |
| input sensitivity/impedance (others) | 335 mV/47 kΩ |
| phono overload level | 120 mV (T.H.D. 0.1 %, 1 kHz) |
| frequency response (phono mm) | 20 Hz to 20, 000 Hz ±0.3 dB |
| frequency response (others) | 5 Hz to 100, 000 Hz dB–3 |
| output level/impedance | 335 mV/1 kΩ |
| tone control (bass) | ± 6 dB (100 Hz) |
| tone control (treble) | ± 6 dB (10 kHz) |
| loudness | +3 dB (100 Hz/10 kHz) |
| signal-to-noise ratio (phono mm) | 80 dB |
| signal-to-noise ratio (others) | 101 dB |
Video Section (S jack)| input sensitivity/impedance | 1 Vp-p/75 Ω luminance, 0.268 Vp-p/75 Ω chrominance |
|---|---|
| output level/impedance | 1 Vp-p/75 Ω luminance, 0.268 Vp-p/75 Ω chrominance |
| frequency response | 5 Hz to 10 MHz dB–3 |
| signal-to-noise ratio | 65 dB |
| isolation | 55 dB (3.58 MHz) |
Video Section (Composite)| input sensitivity/impedance | 1 Vp-p/75 Ω |
|---|---|
| output level/impedance | 1 Vp-p/75 Ω |
| frequency response | 5 Hz to 10 MHz dB+0–3 |
| signal-to-noise ratio | 65 dB |
| isolation | 55 dB |
Power| power requirements (UK model) | AC 230 V, 50/60 Hz |
|---|---|
| power requirements (European model) | AC 220 - 230 V, 50/60 Hz |
| power consumption | 500 W |
| power consumption in standby mode | 1.0 W |
| AC outlets (SWITCHED) | Total 100 W MAX. |
| AC outlets (UNSWITCHED) | 100 W MAX. |
Weight and Dimensions| dimensions | 420 (W) × 173 (H) × 470 (D) mm |
|---|---|
| weight | 17.2 kg |
To Next Page
