Pioneer X-EM21 - Programming Tracks; For a CD; For WMA;MP3 Files; Erasing the Program

Playing 05
15
En
English
Français Español
Programming tracks
Note
• You can program up to 20 tracks.
• During programming, if no operation is made within 20
seconds, the system returns to the stop mode without
saving earlier operations.
For a CD
1 Press  to stop playback.
[T0], the total number of tracks, and the duration time are
displayed.
2 Press PROGRAM to activate the
programming.
[PROG.] and [P01] (the sequence number) are displayed with
[00] blinking.
3 Press / to select a track.
The track number blinks.
4 Press PROGRAM again to program the
selected track.
5 Repeat steps 3 and 4 to program more
tracks.
6 Press
 to start playback.
For WMA/MP3 files
1 Press  to stop playback.
[A XXX] (XXX indicates the total number of albums) and
[T XXX] (XXX indicates the total number of tracks) are
displayed.
2 Press PROGRAM to activate the
programming.
[PROG.] and [P01] are displayed with [A00] blinking.
3 Press / repeatedly to select an album.
[AXX] (XX indicates the album number) blinks.
4 Press PROGRAM again to confirm the
selected album.
[T00] blinks.
5 Press / repeatedly to select a track.
[TXX] (XX indicates the track number) blinks.
6 Press PROGRAM again to confirm the
selected track.
7 Repeat steps 3 to 6 to program more tracks.
8 Press
 to start playback.
Erasing the program
 To erase the program,
• Switch to another source.
X-EM21_SYXE8_En.book Page 15 Thursday, June 7, 2012 9:43 AM
601-EM2100-010.pdf 15 2012/7/5 11:25:06