Pioneer XC-P410T Operating Instructions

TO PLAY ONLY DESIRED TRACKS/DISCS
Programming a pause
nserting a pause in your program can be very useful when
carrying out recording. Press PAUSE i instead of entering a
track number. “PA” appears on the display panel.
@ For example, when recording on both sides of a cassette
tape, if you program a pause after the last track to be
recorded on the first side, program playback will pause
at that point to allow you to switch tape sides. To resume
program playback after the player enters pause mode,
press PAUSE a1.
NOTES:
@ A pause cannot be programmed at the beginning of a
program {P-01), nor can two pauses be programmed
one after the other.
e A pause inserted in a program is counted as one step.
@ Ifa pause is programmed as the last step of a program,
the player will not enter pause mode.
To clear all of the program contents
® > During stop mode, press STOP
STOP
+ Press OPEN/CLOSE to open the disc tray.
x
CLOSE
NOTE:
Opening the disc tray |, program contents for DISC / will be
cleared.
Opening the disc tray Ii, program contents for DISC If will be
cleared.
24
<RRB1090>
En
HOW"
CHECK |
Bear in mi
tape.
Is the tap
of the ca:
if some of
if the tape
pinch roller
or damage
into the ree
tapes corr
prevents t
tape and re
How can
Acassette
so that im
When the:
the tip of a
recording
button, so
To re-recor
simply stic
areas, as s
In case of 1
the detect
When this
mechanist
NOTE:
The accide
left on bot
side can b
Fig. C
NOTE
TAPE \
r| CORF
ae

Pioneer XC-P410T Specifications

General

Brand	Pioneer
Model	XC-P410T
Category	Car Receiver
Language	English