Pioneer XC-P410T Operating Instructions

PLAYING TAPES
Basic operation
During
@ Tapes may be played back in Deck | or Deck {fl but not in
both decks at the same time.
1 Press EJECT & and load a recorded tape,
then push in the cassette door until it
locks.
2 Set REVERSE MODE.
=: To play on one side of a tape.
=D: To play both sides of a tape. “-
©): To play both sides of a tape repeatedly 8 times (16
sides}.
3 Set DOLBY NR to the same position used
for recording.
Tapes recorded using Dolby noise reduction should always.
be played back with the noise reduction system on.
4 Press PLAY (> or <¢). ———
»: Forward playback
~t: Reverse playback
®To stop playback, press STOP m.
®To fast forward or rewind, press FAST
>> /<< during stop mode.
DOLBY NR
To operate Deck I! with the remote control unit, press the
desired deck operation button while pressing SHIFT
DECK Il.
NOTES:
@ ifthe power is switched off while the tape is running, you 1
may not be able to open the door. In this case, switch on
the power again and press EJECT once more.
@ Confirm that the deck has stopped before pressing
EJECT,
Auto Stop Mechanism
This mechanism automatically stops the tape when the end of 2
the tape is reached. ox
®
STOP
DECK
———_—_
=
Lod
[
The Dolby NR System
Pa ia
The Dolby NR system are designed to reduce high-
frequency noise (tape hiss) generated during playback.
The level of low-volume, high-frequency sounds isincreased
during recording and decreased by the same amount
during playback to restore the original level. At the same
time, high-frequency noise {the most easily perceived by 4
the human ear) is attenuated as well.
Dolby B-type NR system reduces high-frequency tape
noise, widening the dynamic range.
Dolby C-type NR system is even more powerful, applying [ox
the noise reduction effect to a wider spectrum of
frequencies from the middie range.
26
<RRB1IO90>
En

Pioneer XC-P410T Specifications

General

Brand	Pioneer
Model	XC-P410T
Category	Car Receiver
Language	English