Piper PA-28RT-201 Service Manual

LIST OF ILLUSTRATIONS (cont)
FIGURE NO. SUBJECT GRID NO.
ELECTRICAL SCHEMATICS
—NOTE—
Refer to Grid 313 for Electrical Schematic Index.
95-1. Tire Balancer Fixture 3K4
95-2. Control Surface Balancing Tool 3K5
95-3. Ignition Harness Ferrule Seating Tool 3K6
95-4. Needle 3K6
95-5. Assembly Tool for Ignition Harness Insulating
Sleeve Installation 3K6
95-6. Charging Stand 3K7
95-7. York Compressor and Fabricated Oil Dipstick
(PA-28RT-201) 3K7
95-8. Fabricated Gear Back-Up Extender Actuator
Aligning Tool 3K8
95-9. Fabricated Stabilator Rigging Tool 3K9
95-10. Fabricated Aileron and Flap Rigging Tool 3K10
95-11. Fabricated Aileron Bellcrank Rigging Tool 3K11
95-12. Fabricated Rudder Rigging Tool 3K11
95-13. Fabricated Tool for Baggage Door Lock 3K12
95-14. Retainer Ring Tool 3K12
95-15. Orifice Replacement Tool 3K13
Introduction
Page-14
Revised: July 13, 1983
1A15
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL

Piper PA-28RT-201 Specifications

General

Brand	Piper
Model	PA-28RT-201
Category	Aircrafts
Language	English