PIPER AIRCRAFT
PA-28RT-201 / 201T
*MAINTENANCE MANUAL
COMPONENT LUBRICANT FREQUENCY
1. NOSE GEAR STRUT HOUSING GREASE FITTING MIL-G-23827 100 HRS
2. NOSE GEAR PIVOT POINT AND HYDRAULIC
CYLINDER ROD END MIL-L-7870 100 HRS
3. NOSE GEAR DOOR RETRACTION MECHANISM MIL-L-7870 100 HRS
4. NOSE GEAR DOOR HINGES MIL-L-7870 100 HRS
5. EXPOSED OLEO STRUT MIL-L-60326 100 HRS
6. NOSE WHEEL BEARINGS TEXACO MARFAX ALL
PURPOSE GREASE OR
MOBIL GREASE 77 (OR
MOBIL EP2 GREASE) 100 HRS
7. NOSE GEAR DRAG LINK ASSEMBLIES MIL-G-23827 100 HRS
8. NOSE GEAR TORQUE LINK ASSEMBLY AND
STRUT HOUSING MIL-G-23827 100 HRS
9. DOWNLOCK, ROLLER TENSION SPRING, SHIMMY
DAMPENER AND ALIGNING ROLLER PIVOT POINTS MIL-L-7870 100 HRS
10. STEERING BELLCRANK PIVOT POINTS AND
ROD ENDS MIL-G-7711 100 HRS
11. NOSE GEAR OLEO STRUT FILLER POINT MIL-H-5606 AS REQUIRED
12. BUNGEE SPRING MIL-G-7711 100 HRS
13. FIREWALL BUNGEE SEAL AERO LUBRIPLATE. MAG-1
OR AERO SHELL #7 100 HRS
SPECIAL INSTRUCTIONS
1. Nose Wheel Bearings - Disassemble and clean with a dry type solvent. Ascertain that grease is packed between
the roller and cone. Do not pack grease in wheel housing. Wheel bearings require cleaning and repacking after
exposure to an abnormal quantity of water.
2. Oleo Struts - Fill per instructions on unit or refer to Maintenance Manual
THIS SPACE INTENTIONALLY LEFT BLANK
Figure 12-5. Lubrication Chart (Landing Gear, Nose)
12-20-32
Page 12-19
Revised: July 24, 1981
1E2