Pitco SSRS14 - User Manual

Questions and Answers

L
Leslie HughesAug 12, 2025
Why Pitco Pasta Maker controller does not activate?
- B
  brownkristineAug 12, 2025
  If the Pitco Pasta Maker's controller isn't activating, several factors could be at play. First, ensure the appliance is receiving power by checking the power cord and the building's main power supply. A tripped circuit breaker could also be the culprit; try resetting it. Verify that the I/O button is pressed to the 'On' position, and that the controller itself is turned on. Finally, make sure the power cord is securely connected.
P
Peggy BeasleyAug 18, 2025
What to do if Pitco Pasta Maker controller displays heating but water won't heat?
- K
  Kelly NelsonAug 19, 2025
  If your Pitco Pasta Maker's controller indicates it's heating, but the water remains cold, it's possible that the high-temperature limit(s) have been tripped. In this case, allow the appliance to cool down completely, and then reset the high-temperature limit(s).
M
Mark GonzalezAug 27, 2025
What to do if water temperature is low in Pitco Pasta Maker?
- M
  Mary GonzalezAug 27, 2025
  If the water temperature in your Pitco Pasta Maker is too low, allow the appliance to heat up. If the issue persists, turn off the appliance, let it cool completely, then refill it with water before turning it back on.
C
caseypenaSep 3, 2025
What to do if drain valve is open while Pitco Pasta Maker controller is on?
- C
  Cody BeltranSep 3, 2025
  If the drain valve is open while the controller of your Pitco Pasta Maker is on, turn off the appliance. Then, close the drain valve before turning the appliance back on.