54 /64
Installation, use and maintenance
15.1 FUEL DISPENSING
ATTENTION
Fuel shall be ABSOLUTELY dispensed under the User’s strict supervision.
In case of simple configuration (no optional data to be entered), dispensing
takes place as follows:
1
Enter PIN CODE
If the management system identifies an enabled pin code, the following mes-
sages are displayed and the pump is enabled.
ENTER PIN CODE
GOOD MORNING USER
2
Uncoil the hose from the hook and take the nozzle out of its seat.The manage-
ment system starts the pump.
ATTENTION
Never operate nozzle lever before putting the nozzle in the container to
be filled.
3
Operate nozzle lever to start dispensing fuel.
The management system displays quantity supplied.
ATTENTION
Dispensing can be stopped when desired. In case of prolonged break
(break time can be set by the Manager at Configuration stage), the pump is
stopped and disabled. Repeat operations from point 1. to resume dispens-
ing.
4
After dispensing, coil the hose on the hook and put the nozzle back in its seat.
The management system stops the pump
ATTENTION
If there is a power cut or the pump stops, the operator has to put the nozzle
back in theunit seat. Remember that the nozzle can be opened only when
the spout is in the tank.
16 MAINTENANCE
16.1 ROUTINE MAINTENANCE
CUBE MC has been designed so as to require minimum maintenance. For
utmost station efficiency and safety, the following inspection and ROUTINE
maintenance operations should however be regularly performed.
Safety instruc-
tions
The dispensing system was designed and built to require a minimal amount
of maintenance. Before carrying out any maintenance work, disconnect the
dispensing system from any electrical and hydraulic power source. During
maintenance, the use of personal protective equipment (PPE) is compulsory.
In any case always bear in mind the following basic recommendations for a
good functioning of the dispensing system
Authorised
maintenance
personnel
All maintenance must be performed by qualified personnel. Tampering can
lead to performance degradation, danger to persons and/or property and
may result in the warranty being voided.
ATTENTION
The maintenance of the electrical parts can 'be done only by qualified in-
staller electrical or electronic.
Before performing any maintenance make sure to unplug the device from
the power supply to turn it off and isolate it from the mains.
If the device is sold without cable to provide periodic verification of the
circuit grounding in accordance with current regulations
To Next Page
Loading...
