11. FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Caution:
Any changes or modifications in construction of this device which are not
expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Re-orientate, or relocate, the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
12. DISCLAIMER
Cape Evolution, Ltd., the producer of the Pivothead products, does not promote,
endorse or intend for its products to be used in high risk, careless or dangerous
activities, and is not responsible for any injuries or property damage arising from
any user activities. Cape Evolution, Ltd. will not under any circumstances be
responsible for injuries or property damages resulting from any misuse, illegal
use, or unintended use of its products. Cape Evolution is not responsible for any
illegal action taken while recording or editing video or still images captured with
our products. The Pivothead products are intended to be used to capture images
and recordings in strict compliance with all applicable federal, state and local
laws and regulations. It is the user’s responsibility to comply with such laws and
regulations
To Next Page