Your Pivothead HDHF recorder is configured with the following default settings:
Video Resolution: 1080p @ 30fps
Video mode: Active
Still Photo Resolution: 8 Megapixels
Pressing the Video Recording Button (B1) will start HD video recording
Pressing the Photo Recording Button (B2) will start taking picture.
Give it a try!
4. Powering ON and OFF the glasses
A Steady Blue LED light (D) indicates that the PIVOTHEAD HDHF recorder is
switched ON.
• To power ON the PIVOTHEAD HDHF recorder:
Press and release the power button when the device is switched OFF. The LED
Power Light (Blue) on the left temple of the camera will switch on.
• To power OFF the PIVOTHEAD HDHF recorder:
Press and release the power button when the device is switched ON. The LED
Power Light (Blue) will switch off.
a) Record Video
• To begin recording video:
Press and release the Front Shutter Button (B1). The recorder’s Red recording
LED light (C) will flash while recording continues.
• To stop recording:
Press and release the Front Shutter Button (B1). The LED Recording Light will
stop flashing. Recording will automatically stop when the internal memory is full
or the battery runs out of power. Your video will be saved before the camera
powers off.
LED indication for low battery or memory full:
(red + blue light continuous blinking) = internal memory is full
(red light on and & blue light continuously blinking) = low power & memory full
(blue light slow blink) = low battery (10%)
(blue light rapid blink = very low power (below 3%), glasses will shut down after
five blinks
To Next Page
Loading...