Why can't I watch images while driving with my Planet Audio Car Receiver?
If you cannot watch images on your Planet Audio Car Receiver while driving, it is because viewing images while driving is not permitted. To resolve this, park your car in a safe location, shift to the 'P' (Park) position, engage the hand brake, and ensure the parking brake wire is grounded.
How to fix a Planet Audio Stereo Receiver that won't turn on?
If your Planet Audio Stereo Receiver isn't turning on and there's no sound, the fuse may be blown. Replace it with a fuse of the same amperage. If it blows again, consult your store of purchase. Also, incorrect wiring may be the cause. Consult your local retailer.
What to do if my Planet Audio Stereo Receiver won't load a disc?
If your Planet Audio Stereo Receiver isn't loading discs, it might be because there's already a disc inside the player. Remove the disc and then insert a new one.
Why does my Planet Audio Stereo Receiver keep skipping?
If your Planet Audio Stereo Receiver is skipping sound, it could be due to a few reasons. First, ensure that the installation angle is less than 30 degrees. If the issue persists, the disc might be dirty or defective. Clean the compact disc or try playing a new one.
Why is my Planet Audio Stereo Receiver radio not working?
If you are experiencing issues with your Planet Audio Stereo Receiver's radio, and automatic station selection isn't working, the antenna cable may not be properly connected, or the signals might be too weak. Ensure the antenna cable is firmly inserted and try selecting a station manually.
What to do if my Planet Audio Stereo Receiver can't read a disc?
If your Planet Audio Stereo Receiver isn't reading discs, make sure you're inserting the compact disc with the label facing upward. If the issue continues, the disc might be extremely dirty or defective, so try cleaning it or using a new one. Also, if the temperature inside the car is too high, cool it off until the ambient temperature returns to normal.
What to do if my Planet Audio Car Receiver cannot load disk?
If your Planet Audio Car Receiver cannot load a disc, it might be because there is already a disc inside. Remove the existing disc before trying to insert another one.
How to fix a Planet Audio Car Receiver that cannot power on?
If your Planet Audio Car Receiver will not power on, there are a couple of things you can check: * First, examine fuse C and replace it with a new fuse that is the same type as the old one. * Second, if some factors cause the MPU to operate incorrectly, press the RES button on the panel with a penpoint, and then power the unit on.
What to do if Planet Audio Stereo Receiver has no sound with amplifiers or power antenna?
If you're experiencing no sound output when operating your Planet Audio Stereo Receiver with amplifiers or a power antenna attached, the power antenna lead might be shorted to ground, requiring excessive current, or there may be an issue with the remote on the amplifiers or power antenna. Here’s what to do: 1. Turn off the unit. 2. Remove all wires attached to the power antenna lead, and check each wire for a possible short to ground using an ohm meter. 3. Turn on the unit. 4. Reconnect each amplifier remote wire to the power antenna lead one by one. If the amplifiers turn off before all wires are attached, use an external replay to provide remote-on voltage (excessive current required).
Why does my Planet Audio Stereo Receiver sound bad when I first turn it on?
If your Planet Audio Stereo Receiver produces bad sound right after being turned on, and you're using compact discs, the disc itself might be dirty. Clean the compact disc without scratching it. Alternatively, the compact disc might be heavily scratched or warped. Replace it with a compact disc without scratches.
General| MP3 playback | Yes |
|---|---|
| Playback disc formats | CD audio, DVD-Audio, DVD-Video |
| Audio formats supported | MP3, MP4, WMA |
| Image formats supported | JPG |
| Video formats supported | AVI |
| Supported radio bands | AM, FM |
| Preset stations quantity | 30 |
| DIN size | 1 DIN |
| Output power | 340 W |
| Product color | Black |
| Ready for iPod | No |
| Disc types supported | CD, CD-R, CD-RW, DVD, DVD+R, DVD+RW, DVD-R, DVD-RW |
| Audio output channels | 4.0 channels |
| Maximum power per channel | 85 W |
| Display diagonal | 7 \ |
| USB version | 2.0 |
| USB ports quantity | 2 |
| Bluetooth functions | Audiostreaming, Handsfree calling |
| Compatible memory cards | SD |
Weight and Dimensions| Dimensions (WxDxH) | 181 x 54 x 190 mm |
|---|
To Next Page
