What to do if my Planet Audio PATV65 unit will not turn on?
If your Planet Audio stereo system isn't turning on, the fuse may be blown or there could be a bad accessory power connection. Check and replace the fuse if necessary. Also, check the accessory power port for proper operational voltage.
What to do if my Planet Audio PATV65 Stereo System has no sound?
If you're not hearing any sound from your Planet Audio stereo system, there are a few potential causes: * A speaker might be blown, in which case you should replace the faulty speaker. * The volume might be set too low or muted. Try increasing the volume level. * The device connected to the stereo system might be paused or muted. Check the playing and volume status of your connected device.
Why has my Planet Audio Stereo System become unresponsive?
If your Planet Audio unit has become unresponsive, it might be due to a power glitch or interference. Try disconnecting the power for 10 seconds to reset it.
Why is the audio quality poor after connecting my Planet Audio PATV65 Stereo System with Bluetooth?
Poor audio quality after connecting to a Bluetooth device could be due to poor Bluetooth reception. Try moving the device closer to the audio system or removing any obstacles between the device and the system's antenna.
General| Channels | 2 |
|---|---|
| Bluetooth | Yes |
| USB Port | Yes |
| Aux Input | Yes |
| Subwoofer Output | Yes |
| Amplifier | Built-in |
| Inputs | Bluetooth, USB, Aux |
| Weatherproof | Yes |
| Frequency Response | 45 Hz to 25 kHz |
| Input Voltage | 12V |
| Speakers | 6.5” |
Guidelines for safe operation, including volume limits and emergency procedures.
Warnings about professional installation, wiring safety, and potential hazards.
Instructions for mounting the unit using double-sided tape or velcro.
Procedure for attaching the unit to a handlebar using the provided clamp kit.
Detailed explanation of each button and indicator on the MFC unit.
Step-by-step guide for connecting a device via Bluetooth.
Steps to re-establish a Bluetooth connection with a previously paired device.
Using the MFC buttons to control music playback and skip tracks.
Adjusting the audio volume using the MFC buttons.
Steps to connect and operate devices using the 3.5mm AUX-IN port.
Adjusting audio volume and muting the system via the MFC.
Details on how the device complies with FCC rules and RF exposure guidelines.
To Next Page