4
ENGLISH
BEFORE INSTALLING THIS PRODUCT
When replacing the fuse, be sure to only use a fuse of the
rating specied on this product.
To avoid short-circuiting, cover any disconnected leads with insulating tape. It is
especially important to insulate any unused wires, which if left uncovered may
cause a short circuit. When connecting other devices to this product, refer to the
manual for the product to be connected. The black cable is ground, make sure to
connect the ground wire rst.
Ensure that the ground cable is properly connected to metal parts of the vehicles
body frame or direct to the battery if your vehicle does not have a grounded
chassis frame The ground cable of this units power amp and a second powered
system must be connected to the frame separately with dierent screws. If the
screw for the ground wire loosens or falls out, it could result in re or malfunction.
To avoid potential shorts in the
electrical system, be sure to disconnect
the (–) battery cable before installation.
Use this unit with a 12-volt battery and
negative grounding only. Failure to do so
may result in a re or malfunction.
To Next Page
Loading...
Need help?
General