- 9 -
- 10 - - 12 - - 13 - - 14 -
- 11 -
B. Connect the other end of the cable to the
network devices such as routers, Ethernet
switches or NVRs (network video recorders).
Step 4: Connect your FSD-604HP to PoE PDs.
A. Connect one end of a standard network
cable to one of the four 10/100Mbps RJ45
PoE+ ports of the FSD-604HP.
B. Connect the other end of the cable to the
802.3at/af PD.
Office Building Office Area
Warehouse
Control Room
Office Building
FSD-604HP
DC
Power Line (DC)
100BASE-TX UTP
PoE
100BASE-TX UTP with PoE
IEEE 802.3af PoE
VoIP Phone
IEEE 802.3at
PoE IP Camera
Fixed IP Dome
IEEE 802.3af PoE Splitter
DC
IEEE 802.3af
PoE IP Camera
PoE Extender
PoE
PoE
PoE
PoE
Wall-mount Installation
Step 1: Please nd the wall that can mount the
FSD-604HP.
Step 2: Please refer to the picture below and screw the
two screws on the wall.
122mm
Step 3: Hang the FSD-604HP on the screws from the
wall.
Step 4: Repeat step 5 of Desktop Installation for
power supply to the FSD-604HP.
Note
Before mounting the device to the wall,
please check the location of the electrical
outlet and the length of the Ethernet cable.
Note
Cable distance for Switch
If the “DIP Switch Mode” is set to
“Standard”, then the distance between
the FSD-604HP and PC/PD should not ex-
ceed 100 meters for UTP/STP cable.
If the “DIP Switch Mode” is set to “Ex-
tend”, then the distance between the
FSD-604HP and PC/PD should not exceed
250 meters.
Note
Make sure the wiring is correct
Category 3/4/5 cable can be used in 10
Mbps operation. To reliably operate your
network at 100Mbps, you must use an un-
shielded twisted-pair (UTP) Category 5/5e
cable, or better data grade cabling. While a
Category 3 or 4 cable may initially seem to
work, it will soon cause data loss.
Step 5: Supply power to the FSD-604HP.
A. Connect one end of the power cable to the
Switch.
B. Connect the power plug of the power cable
to a standard wall outlet.
When the Switch receives power, the power LED should
remain solid Orange.
7. Product Specications
Model
FSD-604HP
4-Port 10/100Mbps 802.3af/at PoE +
2-Port 10/100Mbps Desktop Switch
Hardware Specications
Network Connector
6-Port RJ45 for 10/100BASE-TX, auto
MDI/MDIX
PoE Inject Port
4-Port with 802.3af/at PoE injector
function (Port 1 to port 4)
LED Display
System: Power (Orange)
Per PoE port: PoE (Orange, port 1 to
port 4)
LNK/ACT (Green, port 1 to port 6)
DIP Switch
Distance in Standard mode is 100M
Distance in Extend Mode is 250M
Base on the cable category
Switch Architecture Store and Forward switch architecture
MAC Address Table
2K MAC address table with auto
learning function
ESD Protection 6KV
Switch Fabric 1.2Gbps
Switch Throughput 0.89Mpps @64bytes
Maximum Packet Size 1536bytes
Flow Control
Back pressure for half duplex. IEEE
802.3x pause frame for full duplex
Power Requirements AC 100~240V, 2A max.
Power Consumption Max. 63 watts, 214 BTU
Dimensions (W
x
D
x
H) 168 x 93 x 32mm
Weight 499g
Power over Ethernet
PoE Standard
IEEE 802.3af Power over Ethernet/PSE
IEEE 802.3at Power over Ethernet Plus/
PSE
PoE Power Supply Type End-span
Power Pin Assignment 1/2 (+), 3/6(-)
PoE Power Output
Per Port 52V DC, 300mA. max. 15.4
watts (IEEE 802.3af)
Per Port 52V DC, 600mA. max. 30
watts (IEEE 802.3at)
PoE Power Budget 60 watts
Number of PDs
(7
watts) 4
Number of PDs
(15.4 watts)
4
Number of PDs
(30 watts)
2
Standard Conformance
EMI Safety CE, FCC
Standard Compliance
IEEE 802.3
IEEE 802.3u
IEEE 802.3x
IEEE 802.3af
IEEE 802.3at
Ethernet
Fast Ethernet
Flow Control
Power over Ethernet
Power over Ethernet Plus
Environment
Operating Environment 0 ~ 50 degrees C
Storage Environment -10 ~ 70 degrees C
Operating Humidity
5 ~ 95%, relative humidity, non-
condensing
Storage Humidity
5 ~ 95%, relative humidity, non-
condensing
8. Customer Support
Thank you for purchasing PLANET products. You can
browse our online FAQ resource on PLANET Website
rst to check if it could solve your issue. If you need
more support information, please contact PLANET switch
support team.
PLANET online FAQ:
http://www.planet.com.tw/en/support/faq.php?type1=1
Switch support team mail address:
support_switch@planet.com.tw
Copyright © PLANET Technology Corp. 2017.
Contents are subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp. All
other trademarks belong to their respective owners.
To Next Page
Need help?
General
