6
3.1 Logging on to Console
Once the terminal is connected to the device, power on the L2+ Managed PoE+
Switch and the terminal will display “running testing procedures”. Then, the
following message asks to log in user name and password. The factory default
user name and password are shown as follows and the login screen in Figure 3-3
appears.
Username:admin
Password:admin
Figure 3-3: L2+ Managed PoE+ Switch Console Login Screen
Theuser cannow entercommands tomanagethe L2+Managed PoE+ Switch.For
adetaileddescriptionofthecommands,pleaserefertothefollowingchapters.
Note
1.For securityreason, pleasechange andmemorize thenew pass-
wordafterthisfirstsetup.
2.Only accept command in lowercase letter under console inter-
face.
To Next Page
Loading...
