5
LED indications:
The rear panel of the MC-700 is with one fan, one ON/OFF Switch and a
power inlet that accept 100~240V AC, 50/60Hz power input.
Fig. 4 Rear view of MC-700
Printing LED Status Description
ON The chassis is powered PWR
OFF
The chassis is not powered or power failure if the
AC outlet is with 100~240V AC voltage. Please
consult your local dealer if power failure.
ON The fan is functional ok FAN
OFF
The fan is not powered or it is malfunction. If the
fan LED remains off while power is on. Please
consult your local dealer to replace the FAN.
Power Notice:
1. The device is a power-
required device, it means, it will not work till it is
powered. If your networks should active
all the time, please consider
use an UPS (Uninterrupted Power Supply) for your device. It will
prevent you from network data loss or network downtime.
2. In some area, installing a surge suppression device may also help to
protect your chassis from being
damaged by unregulated surge or
current to the converter or the power adapter.
3.MC-700 provide 22watt total power dissipation, MC-700 maximum
allow to install 2 gigabit Converter in each MC-700.
To Next Page
Loading...
Need help?
General
