Planet VC-102S - User Manual

To Next Page

Trademarks

Contents subject to revise without prior notice.

PLANET is a registered trademark of PLANET Technology Corp.

All other trademarks belong to their respective owners.

Disclaimer

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation, This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the Instruc-

tion manual, may cause harmful interference to radio communications, how-

ever, there is no guarantee that interface will not occur in a particular instal-

lation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause

radio interference, in which case the user may be required to take adequate

measures.

Revision

Ethernet Over VDSL Converter User’s Manual

FOR MODELS: VC-102M / VC-102S

Part No.: EM-VC102

Main Page

Need help?

Do you have a question about the Planet VC-102S and is the answer not in the manual?

Planet VC-102S Specifications

General

Model	VC-102S
Fiber Mode	Single-mode
Fiber Connector	SC
Max. Distance	20 km
Wavelength	1310 nm
Data Transfer Rate	100 Mbps
Power Input	5V DC
Power Supply	External Power Adapter
Operating Temperature	0°C to 50°C
Storage Temperature	-20°C to 70°C
Standards	IEEE 802.3u
Humidity	5% to 90% (non-condensing)

Summary

Chapter 1 Introduction

1.1 Checklist

Check package contents for Ethernet over VDSL Converter, Power Adapter, Telephone line, and User's Manual.

1.2 Introduction to Ethernet over VDSL Converter

Explains the converter's switching architecture, RJ45/RJ11 ports, and its use for signal conversion over telephone cables.

1.3 Key Features

Highlights key features: Cisco LRE compatibility, IEEE standards, selectable modes, QAM line code, FDD, and diagnostic LEDs.

1.4 Specifications

Details product specifications: model, ports, LEDs, DIP switch, modes, distances, cables, splitter, memory, dimensions, environment, and certification.