Planet VC-102M - User Manual

Trademarks
Copyright  PLANET Technology Corp. 2003.
Contents subject to revise without prior notice.
PLANET is a registered trademark of PLANET Technology Corp.
All other trademarks belong to their respective owners.
Disclaimer
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation, This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the Instruc-
tion manual, may cause harmful interference to radio communications, how-
ever, there is no guarantee that interface will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures.
Revision
Ethernet Over VDSL Converter User’s Manual
FOR MODELS: VC-102M / VC-102S
Part No.: EM-VC102

Planet VC-102M Specifications

General

Type	Media Converter
Model	VC-102M
Standards	IEEE 802.3, IEEE 802.3u
Fiber Type	Multi-mode
Wavelength	850 nm
Transfer Distance	2 km
Power Supply	5V DC

Summary

Trademarks

Disclaimer

CE Mark Warning

Revision

Chapter 1 Introduction

1.1 Checklist

Details the contents of the product package for verification.

1.2 Introduction to Ethernet over VDSL Converter

Explains the technology and benefits of the Ethernet over VDSL Converter.

1.3 Key Features

Lists the key features and capabilities of the converter.

1.4 Specifications

Provides detailed technical specifications for the VC-102M and VC-102S models.

Chapter 2 Hardware Description

2.1 Front Panel and LED Indicators

Describes the front panel layout, including status and diagnostic LED indicators.

2.2 MODE DIP Switch (VC-102 M only)

Explains the function and settings of the MODE DIP switch for transmission mode selection.

2.3 Rear Panel

Details the rear panel connectors, including power input and telephone/network ports.

Chapter 3 Installing and Using VDSL Converter

3.1 Install the Ethernet Over VDSL Converter

Provides general installation instructions, noting no software configuration is needed.

3.1.1 LAN to LAN Connection

Guides connecting two local networks using converters for point-to-point communication.

3.1.2 Connect to Multi-Port Master

Explains connecting the converter to a multi-port master for building local networks.

3.2 Connecting VC-102 M;S

Guides users through connecting the converter to standalone PCs and Ethernet LANs.

3.2.1 Connecting Standalone PC

Step-by-step guide for connecting the converter to a single PC.

3.2.2 Connecting Multiple PCs to an Ethernet LAN

Instructions for connecting the converter to multiple PCs within an Ethernet LAN.

Chapter 4 Troubleshooting

VDSL LNK LED Not Lit

Troubleshoots issues where the VDSL LNK LED does not illuminate after connection.

Switch LNK;ACT LED Not Lit

Troubleshoots the scenario where the Ethernet LNK/ACT LED remains dark.