Planet WGSW-28040 - Configuring Ip Address Via The Console

7
5.ConguringIPAddressviatheConsole
TheWGSWManagedSwitchisshippedwithdefaultIPaddressasfollows:
IPAddress:192.168.0.100
SubnetMask:255.255.255.0
To check the current IPaddress or modify a new IPaddress for the Switch, please
usetheproceduresasfollows:
 Display of the current IP address
1. On “WGSW-28040#”prompt,enter“show ip”.
2. The screen displaysthe current IP address, Subnet Mask and Gatewayshown in
Figure5-1.
Figure 5-1: IP Information Screen
 Conguration of the IP address
1. On “WGSW-28040#”prompt,enter“congure”.
2. On “WGSW-28040(cong)#” prompt,enter the following command andpress
<Enter>asshowninFigure5-2.
WGSW-28040(cong)# ip address 192.168.1.100 mask 255.255.255.0
WGSW-28040(cong)# ip default-gateway 192.168.1.254