’EAP Fast’ authentication type also have a sub-menu to set EAP fast-specific
arameters: p
If you need to use protected authentication credential, check ‘Use protected
authentication credential’ box, and click ‘Import’ to load .pac credential file; to
remove a loaded credential file, click ‘Remove’.
Session
Resumption please ask your 802.1x
You can enable or disable session resumption here. If you don’t know if you
should enable session resumption or not,
authentication administrator.
ID \ Password
tab ssword’ to show the password you typed.
Input 802.1x username (ID) and password and other information if it is
required here. Click ‘Show Pa
Client
Certification tab
Use this tab to select a local certificate from dropdown menu. If the access
point you wish to connect required a specific client certificate, the certificate
must be installed on your computer, and you can select the certificate here.
Server
Certification tab
Use this tab to use server-based certification. Please select a CA (Certificate
Authority) from dropdown menu. If intermediate certificates are allowed,
full
please select ‘Allow intermediate certificates’. Also, if you need to specify CA
server’s name, you can specify it in ‘Server name’ field. You can select
‘Server name must match’, so the CA server’s name must be the same with
the value you set in ‘Server name’ field; If only the domain name part of
server name must the same with the value you set in ‘Server name’ field,
To Next Page
Loading...
Need help?
General
