(Key1 ~ Key4) two types of key length: 64-bit and 128-bit. Select the default
4-bit – Input 10-digit Hex values (in the “A-F”, “a-f” and “0-9” range) or 5-digit
) as the encryption keys. For
s (in the “A-F”, “a-f” and “0-9” range) or
3-digit ASCII characters (including “a-z” and “0-9”) as the encryption keys.
There are
encryption key from Key 1 to Key 4 by selected the radio button.
Fill the text box by following the rules below:
6
ASCII characters (including “a-z” and “0-9”
example: “0123456aef“ or “test1”.
128-bit – Input 26-digit Hex value
1
For example: “01234567890123456789abcdef“or “administrator”.
3-1-3 Using
or the access point. Please click ‘802.1X’ tab:
802.11x
To set 802.1x authentication f
Here are descriptions of every setup item:
Parameter Description
EAP Method Select 802.1x EAP method from dropdown menu. Please ask the
r of the access point you wish to connect to select a correct EAP administrato
method.
Tunnel
Authentication
istrator of the access point you wish to connect to select a correct
is
lways 'Generic Token Card' and can not be changed. You also need to
Select 802.1x tunnel authentication type from dropdown menu. Please ask
the admin
tunnel authentication method. This pull down menu is only available when
authentication type you use is 'PEAP', ‘TLS / Smart Card', or 'TTLS'.
When you use 'EAP-FAST' as authentication type, the protocol setting
a
select ‘Soft Token’ or ‘Static Password’ as password in ‘ID \ Password’
setting.
To Next Page
Loading...
Need help?
General
