3-2 Network-Configuration Utility
After the driver is correctly installed, it will try to connect to any unencrypted wireless access
point automatically. If you want to connect to a specific wireless access point, or the access
point you wish to connect uses encryption, you have to configure the wireless network card
and input required parameters, to get connected to the wireless access point you wish to
connect.
3-2-1 Using configuration Utility
The current status of wireless connection will be displayed by WNL-U554A configuration utility
icon:
Wireless connection is established, good signal reception.
Wireless connection is established, normal signal reception.
Wireless connection is established, weak signal reception.
Wireless network doesn’t connection.
Wireless network card is not detected.
There are two ways you can configure WNL-U554A network card to connect to wireless
access point: using the WNL-U554A configuration utility and using built-in windows zero
configuration utility.
To Next Page
Loading...
