AMPLIFIER CONFIGURATION SELECTOR CONTINUED
RCA BRIDGED MONO. This option configures the whole amplifier to drive one loudspeaker from one
unbalanced signal fed to the RIGHT RCA input. See page 7 & 17. The loudspeaker is connected to both
channels + (positive) output terminals. DO NOT CONNECT ANYTHING AT ALL TO THE -
(NEGATIVE) TERMINALS.
See page 8 & 17 - 18. The power available in this mode is approximately four times the rated output of
the amplifier. Approximately 200 Watts into 8 ohms.
XLR STEREO This option provides a stereo output signal from a BALANCED input stereo signal
connected to both the left and right XLR inputs. See pages 7 & 14. All the advantages of Balanced line
transmission will be realised with good rejection of noise and some freedom from earth or ground loops
(hum). Connect the loudspeakers to both channels as discussed in "OUTPUT TERMINALS STEREO"
page 8 & 15 - 16.
XLR BALANCED MONO. The SA-50 operates as a true balanced mono amplifier, from input to
output. This configuration provides the highest quality mono performance from a balanced line input
connected to the RIGHT BALANCED XLR INPUT. See page 7 & 18. The loudspeaker is connected to
both channels + (positive) output terminals as discussed in OUTPUT TERMINALS BRIDGED MONO
page 18.
The power available in this mode is approximately four times the rated output of the amplifier.
Approximately 200 Watts into 8 Ohms.
To Next Page
Loading...
