Plinius SA-50 instruction manual. Page 12
INSTALLATION & OPERATION
MAINS VOLTAGE.
CHECK that the mains voltage printed on the rear of this amplifier is similar to the mains voltage
normally supplied to your area.
If in doubt, please consult your Plinius dealer.
PLACEMENT AND VENTILATION.
This SA-50 is designed to operate at a moderately high temperature.
The ideal location is on a rigid stand or floor mounted away from direct contact with any objects,
materials or deep pile carpets which may be effected by the heat or which may interrupt the flow of air
around the amplifier.
When operating the amplifier in Class A quite a lot of heat is generated which should be allowed to
dissipate without restriction. Make sure that no objects are placed on top of the amplifier and that the
heat sinks (cooling fins) are not covered or restricted in any way. Always ensure adequate ventilation.
The Plinius SA-50 design incorporates a very high level of mechanical decoupling of the input and
output. It can however still be influenced by acoustical feedback in the operating environment. The use
of acoustic cones or a suitably spiked amplifier stand or table may further enhance the performance of this
amplifier. Consult your Plinius dealer for further advise if required.
To Next Page
Loading...
