Plinius SA-50 instruction manual. Page 18
CONNECTIONS FOR MONO / BRIDGED OPERATION
MONO / BRIDGED operation of the Plinius SA-50 amplifier is a very high quality method of achieving
very high power output without any compromise of performance. Both channels of the SA-50 combine to
form a single channel or Mono amplifier. The output power available is
equal to four times the rated output of this amplifier and is typically 200 Watts RMS into 8 Ohms.
Special care must be taken connecting the input signal and loudspeakers to ensure safe operation and best
possible performance.
To achieve a STEREO performance in MONO / BRIDGED mode, it will be necessary to have and use
TWO (2) SA-50 power amplifiers. One amplifier for each LEFT and RIGHT channel.
SECTION OF REAR PANEL SHOWING LOCATION OF RIGHT CHANNEL INPUT AND
OUTPUT TERMINALS..
INPUTS
RCA AND XLR INPUTS FOR MONO / BRIDGED OPERATION USE ONLY RIGHT
CHANNEL INPUT TERMINALS.
RCA input for BRIDGED / MONO use is the RIGHT channel RCA INPUT.
To Next Page
Loading...
