Plinius SA-50 instruction manual. Page 19
CONNECTIONS FOR MONO / BRIDGED OPERATION CONTINUED
SELECT "RCA BRIDGED MONO" on the AMPLIFIER CONFIGURATION SELECTOR (ACS).
XLR balanced line input for the MONO / BRIDGED option use RIGHT channel XLR INPUT.
SELECT the "XLR BALANCED MONO" option on the AMPLIFIER CONFIGURATION
SELECTOR (ACS). See page 11.
DO NOT Operate this amplifier with both RCA and XLR cables connected at the same time.
OUTPUT
Output connections are provided to allow the use of most types of high quality loudspeaker cables.
The terminals are very robust 5 way binding posts which allow the use of banana plugs, bare wires, pins,
spades and looped wire or terminals. The hexagonal nut is provided where extra tightening of the
terminal is needed or desired and may be used with a suitable spanner. This is often necessary with some
of the stiff speaker cables used today. Do not over tighten these terminals.
Both sets of loudspeaker terminals are used in a special way when the amplifier is BRIDGED. As the
amplifier is now operating as a MONO or single channel amplifier, you must be very careful to attach the
loudspeaker correctly.
To Next Page
Loading...
