Plockmatic Morgana PowerSquare 160 User Manual

1 - Introduction to the PowerSquare 160 -
Morgana PowerSquare™ 160 User Manual 3
Installation
Your PowerSquare 160 must be installed by a Morgana service engineer.
Special knowledge is needed to install the machine.
CAUTION: Only connect the machine to a mains power supply of the
correct voltage with a good earth-connection, as advised by your service
engineer at the time of installation. The correct machine-voltage is shown on
the label at the mains power supply input on the rear of the machine. A
separate earth connection is connected during installation. If the machine is
connected to the wrong supply, the warranty is cancelled.
How to Get Help
If you have any questions or problems, refer to the problem solving section in
this manual (see “Troubleshooting” on page 47). Contact your PowerSquare
160 supplier for further help.

Plockmatic Morgana PowerSquare 160 Specifications

General

Brand	Plockmatic
Model	Morgana PowerSquare 160
Category	Booklet makers
Language	English