Cutting Blades
1. Use only the correct blade (PLP genuine part) approved for the application and model
Brushcutter.
2. Carefully check the condition of the blades before and after operation.
3. Sharpen dull blades. Replace any blade that is worn, cracked or damaged.
4. If a blade produces eccentric rotation or vibration, replace the blade and the boss adapter with
genuine PLP parts.
Maintenance
Please see HONDA ENGINES Owner’s Manual.
Gearcase
Maintenance Interval
The gearcase should be checked for lubrication after
each 50 hours of use.
Gearcase Lubrication
Remove the cutting attachment and the boss adapter.
Clean any dirt and debris from the area between the boss
adapter and the gearcase. Remove the grease plug from
the side of the gearcase. While rotating the attaching
shaft, inject lithium-base bearing lube (P/N 211337)
through the plug hole until the gearcase is full. Reinstall
the boss adapter and grease plug.
General Cleaning and Tightening
The PLP Trimmer/Brushcutter will provide maximum performance for many, many hours if it is
maintained properly.
Good maintenance includes regular checking of all fasteners for correct tightness, and cleaning the
entire machine.
WARNING
POTENTIAL HAZARD
・When engine is running, cutting head is rotating and other parts are moving.
WHAT CAN HAPPEN
・Contact with rotating cutting head or other moving parts could cause serious personal
injury or death.
HOW TO AVOID THE HAZARD
・Always turn off your Trimmer/Brushcutter before you clean or perform any maintenance on it.
To Next Page
Loading...
