15m (50ft.)
Minimum
4. Do not overfill the fuel tank. Stop filling upper fuel level of the tank (see HONDA ENGINES Owner’
Manual).
5. Wipe up any spilled fuel before starting the engine.
6. Move the Trimmer/ Brushcutter at least 3m away from the fueling location before starting the
engine.
7. Do not remove the Trimmer/ Brushcutter fuel tank cap immediately after stopping the engine.
8. Allow the engine to cool before refueling.
9. Drain the tank and run the engine dry before storing the unit.
10. Store fuel and Trimmer/ Brushcutter away from open flame, sparks and excessive heat. Make
sure fuel vapors cannot reach sparks or open flames from water heaters, furnaces, electric motors,
etc.
Trimmer/ Brushcutter Operating safety
1. THIS TRIMMER/BRUSHCUTTER CAN CAUSE SERIOUS INJURIES. Read the instructions
carefully. Be familiar with all controls and the proper use of the Trimmer/ Brushcutter.
2. Never allow children to operate the Trimmer/ Brushcutter. It is not a toy. Never allow adults to
operate the unit without first reading this Operator’s Manual.
3. Avoid using the Trimmer/ Brushcutter near rocks, gravel, stones and similar material that would
cause harmful missiles.
4. Keep children, bystanders and animals outside
a15m (50ft.) radius from the operator and
Trimmer/ Brushcutter.
5. If you are approached while operating the
Trimmer/ Brushcutter, stop the engine and
cutting attachment rotation.
6. Use the Trimmer/ Brushcutter only in daylight or good artificial light.
7. Never operate the Trimmer/ Brushcutter without proper guards in place.
8. Do not put hands or feet near or under any rotating parts. Keep clear at all times. Keep all parts of
your body away from the rotating cutting attachment and hot surfaces such as the muffler.
9. When cutting heavy brush or small trees, always swing the Brushcutter from right to left to prevent
kick-back.
10. Keep a firm footing and balance. Do not overreach.
11. Use the right tool for the job. Do not use the Trimmer/ Brushcutter for any job that is not
recommended by PLP.
To Next Page
Loading...
