PLS PLS5 - Pendulum Target; Transferring Vertical Lines with Target

Pendul um Tar get
13
Use the PLS
5
pendulum target for a variety of time saving alignment tasks. For square: For con-
sistent accuracy in establishing or checking square, use the PLS
5
target to transfer the laser
beam to the floor surface. To establish square, see page 8 of this manual. Always mount the
PLS
5
laser on the floor stand when establishing square. The pendulum target is designed so the
beams are best seen at this height.
For transfer of vertical lines:
To t ra n s fe r ve r t i c a l ma r ks qu i ck l y an d a c c u ra t e l y to a wa l l :
1.Place the front of the PLS
5
laser against the wall with the #1
forward beam on the mark to be transferred. (If the mark is on the
floor, place the #2 down beam over the mark.)
2.Place the target with its back flat against the wall at the desired
height and move the target until the #3 up beam is centered on
the plastic lined target.
3.Mark the top or bottom of the target arrow pins.
PENDULUM TARGET
FIG. 13