Need help?Do you have a question about the PLS PLS5 and is the answer not in the manual?
General| Brand | PLS |
|---|---|
| Model | PLS5 |
| Category | Laser Level |
| Language | English |
Remove batteries for storage, clean optics, avoid extreme temperatures.
Caution against staring into beam or using optical instruments.
Complies with FDA standards, semiconductor laser diode, low power output.
Improper control use may result in hazardous radiation exposure.
Use #2 down beam for marking, #3 up beam for plumb verification.
Swivel unit on stable surface to mark desired level or grade points.
Use #2 down beam on reference line, center #1 forward beam on target.
Check #5 right beam elevation against #1 forward beam at 90 degrees.
Use two targets 25ft+ apart, measure elevation differences.
Requires 10ft+ vertical height, use #2 down and #3 up beams.
At 50ft, diff <1/8"; at 25ft, diff <1/16".
PLS5: <1/16" @ 25ft, <1/8" @ 50ft. PLS3: <1/8" @ 25ft, <1/4" @ 50ft.
To Next Page
