Connect and Install
Insert the Film Holder
35mm Mounted Film Holder
F
35mm Strip Film Holder
Attention
● The lm holder should be able to be inserted into the scanner smoothly. Do not
push the lm holder hard.
● On the top side of the lm holder you can see ’35 mm Mounted Film Holder’ or
’35 mm Strip Film Holder’. Always keep this side up for correct scan results.
Scan Your Film
You may do one of the following:
● Scan with [Positive] or [Negative] or [Custom]
button
E
j
e
c
t
P
o
s
i
t
i
v
e
N
e
g
a
t
i
v
e
C
u
s
t
o
m
● Scan with QuickScan Plus Application
You may select Custom scan mode to adjust
the cropping areas if necessary.
Preference Settings
OpticFilm 135 Series键键键键 Quick Start Guide
1
3 4
2
Please visit www.plustek.com/OpticFilm135i/QuickStart to
download the software and driver and quick installation guide
for your newly purchased Plustek OpticFilm135i lm scanner.
Activate this checkbox if you do not
want the QuickScan Plus program to
launch after scanning images.
The scanned images will be opened
directly on 3rd party image editing
software. *Please refer to FAQ part on
the rear side of THIS guide.
This function is only for the infrared
built-in model.
P/NO.: 17-07-2BB1010-C
Get started
To Next Page
Need help?
General