Follow the steps below for adding dishwasher salt:
1. Remove the basket and unscrew the reservoir cap.
2. Place the end of the funnel (supplied) into the hole and pour in about 1kg
of dishwasher salt.
3. Before first wash, fill the salt container to its maximum limit with water.
It is normal for a small amount of water to come out of the salt
container.
4. After filling the container, screw back the cap tightly.
5. The salt warning light will stop blinking after the salt container has been
filled with salt.
6. Immediately after filling the salt into the salt container, a washing
program should be started (We suggest to use a short program).
Otherwise the filter system, pump or other important parts of the
machine may be damaged by salty water. This is out of warranty.
The salt container must only be refilled when the salt warning light ( )
in the control panel comes on. Depending on how well the salt dissolves,
the salt warning light may still be on even though the salt container is
filled. If there is no salt warning light in the control panel (for some
models), you can estimate when to fill the salt into the softener by the
cycles that the dishwasher has run.
If salt has spilled, run a soak or quick program to remove it.
NOTE:
To Next Page
Loading...
