41
RF exposure warning
This equipment must be installed and operated in accordance with provided instructions
and must not be co-located or operating in conjunction with any other antenna or trans-
mitter. End-users and installers must be provided with antenna installation instructions
and transmitter operating conditions for satisfying RF exposure compliance.
SAR Value: 1.190W/kg
This device is operation in 5.15 – 5.25GHz frequency range, then restricted in indoor use
only, Outdoor operations in the 5150~5250MHz is prohibit.
This device is slave equipment, the device is not radar detection and not ad-hoc opera-
tion in the DFS band.
Note: Do not disassemble the bumper. Otherwise, the antenna may be damaged, result-
ing in poor reception.
Battery Disposal
HIS PRODUCT CONTAINS A LITHIUM-ION OR NICKEL-METAL HYDRIDE BATTERY. IT MUST
BE DISPOSED OF PROPERLY. CONTACT LOCAL ENVIRONMENTAL AGENCIES FOR INFORMA-
TION ON RECYCLING AND DISPOSAL PLANS IN YOUR AREA.
WARNING EXPLOSION HAZARD
Class I, Division 2, Groups A, B, C, D, T Code T5 Class I, Zone 2, Groups IIC, T5
WARNING - EXPLOSION HAZARD. DO NOT CONNECT OR REMOVE WHEN IN HAZARDOUS
AREA. MAKE SURE ALL COVERS SECURED IN PLACE BEFORE USE.
AVERTISSEMENT – RISQUE D’EXPLOSION. NE PAS CONNECTER OU RETIRER DANS UNE
ZONE DANGEREUSE. S’ASSURER QUE TOUS LES CAPOTS SONT FIXÉS EN PLACE AVANT
UTILISATION.
Main Battery: J.S. Power CO., LTD, P/N: X11BK-M
CLASS 1 LASER PRODUCT
LASERSCHUTZKLASSE 1 PRODUKT TO EN60825
CAUTION THIS APPLIANCE CONTAINS A LASER SYSTEM AND IS CLASSIFIED AS A “CLASS
1 LASER PRODUCT.” TO USE THIS MODEL PROPERLY, READ THE INSTRUCTION MANUAL
CAREFULLY AND KEEP THIS MANUAL FOR FUTURE REFERENCE. IN CASE OF ANY TROUBLE
WITH THIS MODEL, PLEASE CONTACT YOUR NEAREST “AUTHORIZED SERVICE STATION.”
TO PREVENT DIRECT EXPOSURE TO THE LASER BEAM, DO NOT TRY TO OPEN THIS ENCLO-
SURE.
ANNEX IV Symbol for the marking of electrical and electronic equipment
The symbol indicating separate collection for electrical and electronic
equipment consists of the crossed-out wheeled bin, as shown below. The
symbol must be printed visibly, legibly and indelibly.
To Next Page
Loading...