102
MAINTENANCE
General Maintenance
Removing Halogen Bulbs - High/Low Beam
1. P inch the ends of the spring (1)
together and lift until it releases
from the spring retainer.
NOTE: Do not touch a halogen
bulb with bare fingers. Oil from
skin leaves a residue, causing a hot
spot that will shorten the life of the
lamp.
2. Lift spring carefully around wire harness (2) and flip to outside of
housing.
3. With the wire harness attached to the bulb (3), withdraw bulb from
housing.
4. Grasp bulb by metal base and carefully separate bulb from
harness.
Installing the Bu lb
1. Hold bulb by metal base and install into wire harness.
2. Insert bulb into housing.
3. Carefully flip spring back into housing placi ng it around wire
harness.
4. Squeeze spring together until it is over the spring retainer and
release.
5. Verify headlight aim.
Removing Halogen Bulbs - High Beam
1. Remove the wire harness (4).
2. Gasp the bulb (5) firmly and
twist it 1/2 turn
counterclockwise.
3. Remove the bulb from housing
and replace with new bulb.
4. Place the bulb and housing back
inside the hole and turn the
housing 1/2 turn clockwise to
lock into place.
5. Reinstall the wire harness to the
housing.
2
1
3
4
5
To Next Page
Loading...
