72
THE PERFECT FIT
Handlebar Component Fastener Torques
Component Torque
Do not over-tighten
IMPORTANT: Moving a handlebar component without first loosening its
screws/set screws may cut grooves into the handlebar, making it difficult
to secure the component. Do not move a handlebar component without
first loosening its mounting screws/set screws.
Take care to avoid damaging hand warmer/brake switch wires when
moving components.
1. Brake Lever / Master Cylinder
60-80 in-lbs (6.7-9 Nm)
2. Auxiliary Engine Stop Switch Set Screw 12 in-lbs (1.4 Nm)
3. Handlebar Hook Screw Aluminum: 10 ft-lbs (13.5 Nm)
Steel: 18 ft-lbs (24 Nm)
4. Throttle Lever Block Set Screw 27 in-lbs (3 Nm)
5. Throttle Lever Block Cover Screws 6 in-lbs (0.7 Nm)
6. Handlebar Clamp Screws/Bolts 7 ft-lbs (9.5 Nm)
7. PERC Button Screw 35 in-lbs (4 Nm)
Hand Guard Mounts (if applicable) Hand-Tight
To Next Page
Loading...
