48
FEATURES
Instrument Cluster
Rider Information Center
Mode 4 - Programmable Service Interval
The purpose of the programmable service interval is to provide the
consumer and deal er with a convenient reminder for routine
maintenance. When your vehicle leaves the factory, this feature is
turned off. You m ust enable the programmable service interval before
it can be used.
Once the service interval mode is set with the hours when service is
due, the hours of actual engine operation are subtracted from the set
hours until 0 is reached. When the counter reaches 0, the wrench icon
will flash quickly for 5 seconds each time the vehicle is started as a
reminder that the peri odic maintenance is due.
To set the hours, press and hold the mode/override button until the
wrench icon flashes. When it begins to flash, release t he button. The
setting will increase by one hour each time the button is pressed.
Pressing and holding the button will allow the numbers to escal ate
much faster. When the desired time increment i s displayed, release the
button and wait for the wrench to stop flashing. When the wrench
stops blinking, your service hours are set. NOTE: If you scroll past
the intended number, hold the button down until the count turns over t o
0. You can then reset the number.
If the service interval is enabled on your ATV and you wish to turn it
off, toggle to the service interval mode. Press and hold the mode
button for approximately 7 seconds until the word OFF appears in the
Rider Information Center.
To Next Page
Loading...
Need help?
General
