8
NOTE: Gate in OPEN position
PULLTOOPEN GATE OPERATOR COLUMN
MOUNTING MEASUREMENTS
(Open gate to inside of property)
The proper position of the mounting brackets is crucial
to the eciency and leverage of the gate operator. The
distance between the gate operator and the gate is also
determined by the proper position of the mounting
brackets.
NOTE: Gate operator should be in the fully retracted position
before attaching the gate bracket and the post mount
bracket assembly.
Figure 4
PULL-TO-OPEN GATE OPERATOR COLUMN MOUNTING
X
Y
NOTE: Make sure the actuator can swing freely through the
complete travel of the gate. Please contact our Technical
Support dept. to discuss “X” - “Y” measurement needed for
your installation of the Polaris 500 or 700 series operators to
column mount applications.
To Next Page
Loading...
