84
MAINTENANCE AND LUBRICATION
Lubrication Recommendations
Engine Oil
Oil and Filter Change (ATP 330)
8. Reinstall the drain plug. Torque to 14 ft. lbs. (19 Nm).
9. Place shop towels beneath the oil filter. Using an oil filter wrench,
turn the filter countercl ockwise to remove.
10. Using a clean, dry cloth, clean the filter sealing surface on the
crankcase.
11. Lubricate the gasket on the new filter with a film of engine oil.
Check to make sure the gasket is in good condition.
12. Install the new filter and turn by hand until the filter gasket
contacts the sealing surface, then turn and additional 1/2 turn.
13. Remove the dipstick and fill the sump with 2 quarts (1.9 l) of
Polari s Premium 4 synthetic oil.
14. Place the gear selector in park and set the parking brake.
15. St art the engine and let it idle for one to two minutes. Stop the
engine and inspect for leaks.
16. Recheck the oil level and add oil as necessary to bring the level to
the upper mark on the dipstick.
17. Dispose of used filter and oil properly.
To Next Page
Loading...
Need help?
General
