See Owner’s Manual for more information.
WARNING
Hitting obstructions at high speeds
can cause serious injury or death.
Always fasten seat belt when
operating.
2
1. Be sure load (if any) is secured.
2. Connect the seat belt. Adjust so
that the belt fits snug around the
lower part of your hips and over
the shoulder. Passenger must
also fasten seat belt.
3. Put the gear selector lever in the
PARK position.
4. Travel Control Pedal must be in
Neutral and PTO must be
disengaged (OFF).
5. Press and hold the brake pedal.
Tip: Engine will not start unless: Gear
selector is in Park or Neutral,
travel control pedal is in neutral
and PTO is OFF.
6. Turn the key to ON position and
wait for the glow plug light to turn
OFF, turn the key to START
position (for improved cold
weather starting, additional key
cycles maybe required). Release
key when the engine starts.
7. Allow engine to warm to
operating temperature.
8. Move the gear selector lever to
Low or High gear.
9. Release the brake pedal and
slowly press the travel control
pedal in the desired direction of
travel. (The further the pedal is
pressed, the faster the machine
will move.)
To Next Page
Loading...
Need help?
General
