Polaris Genesis 2000

ENGINE
Disassembly/Inspection - Polaris Engines
Inspect condition of reed stuffers and replace if
deformed or damaged. The stuffer should fit
squarely into the reed block.
Remove oil pump.
sealing surface.
Inspect O-ring condition and
Remove flywheel cover bolts, tap cover lightly with a
soft faced hammer and remove cover and gasket.
Inspect starter drive bushing in cover for wear or
damage. Measure inside diameter and replace if
worn beyond service limit. Measure starter drive
shaft O.D., calculate clearance and compare to
specifications.
iStarter Drive Bushing Clearance:
Service Limit:
• 1 .0.10" (
w **?■
:f
3/00
4.16
Polaris Safes /nc.