Polaris Genesis 2000

FINAL DRIVE/JET PUMP/BILGE SYSTEM
Pump Housing Installation
Pump Housing Installation
Review important information regarding pump stud installation on page 5.23 and 5.25 before proceeding with
pump housing installation!
1. Liberally grease large pump-to-hull O-ring and
apply Marine Grade Silicone sealant to O-rings on
bilge siphon and cooling water supply fittings.
2. Apply anti-seize to threads of pump mounting studs.
3. Install pump housing and hold inward against hull.
Apply Marine Grade
Silicone Sealant PN
8560054
4. Torque pump housing nuts in three steps to 20 ft.
lbs. (27.7 Nm) using a criss-cross pattern. Do not
use air tools. Do not over-tighten mounting nuts or
hull damage may occur.
Marine Grade Silicone Sealant
300 iiij tube
Use Criss Cross Torque Pattern On Pump
3/00
5.22
Polaris Sales Inc.