Polaris Genesis 2000

MAINTENANCE/TUNE UP
Hull/Deck
Sacrificial Anode
A zinc sacrificial anode is in place on all models on the
pump housing. The purpose of these anodes is to prevent
corrosion of metal parts due to electrolysis. The mounting
surfaces must be clean and the mounting bolt tight to main
tain a good connection between the pump and anode.
1. Periodically inspect anode for excessive wear.
2. Check bolt to be sure it is tight. If the bolt is loose,
remove anode and clean mounting surfaces on pump
and anode.
3. Apply dielectric grease to bolt threads and contact
surfaces.
4. Tighten bolt securely.
Handlebars/Hand Grips
1. Pull and twist on hand grips to ensure they are not loose.
If loose or wore, the handlebar with grip assembly must
be replaced.
2. Check steering support hub fasteners and make sure
they are tight. Check handlebars and hub for cracks or
damage. Replace if cracked or damaged.
3. Inspect steering arm bolt torque.
Steering Arm Bolt Torque
14ft]bs.(19.3Nm)
Fasteners/Parts/Hoses
Inspect the watercraft for any loose nuts, bolts, fasteners
and hoses. Be sure that all hose clamps are tight. Replace
cracked, damaged, or deteriorating hoses.
3/00
2.38
Polaris Sales Inc.