Polaris Genesis 2000

FINAL DRIVE/JET PUMP/BILGE SYSTEM
Pump Removal
1. On models equipped with reverse, the reverse
link can easily be removed if shifted into reverse
position.
2. Remove bilge siphon hoses from extension
housing.
NOTE: On models equipped with an electric bilge
pump, the number of siphon hoses will vary.
3. Loosen (4) 5/16" mounting bolts. Remove
extension housing (and wedge where applicable).
4. Hold water inlet tube toward main pump body at
the hull so as not to dislodge the O-ring seal while
removing extension housing.
3/00
5.12
Polaris Sales Inc.