Polaris Genesis 2000 - Page 219

HULUDECK, STEERING AND CONTROLS
Speedometer
Speedometer Operation and Inspection
The speedometer is operated by water pressure.
The pressure is supplied to the back of the
speedometer through a hose connected to a fitting
located inside the jet pump intake grate area.
1. If the speedometer becomes inoperative first
check hose for kinks or restrictions. Check to see
that it is connected properly to fitting and to back
of speedometer. The fitting must be aligned with
the pump intake grate to read accurately.
2. Occasionally foreign debris such as grass or
weeds will lodge in the fitting or line. To clear
hose and fitting, disconnect hose from
speedometer and apply low pressure air to hose.
3. To test speedometer unit, connect a Mity Vac™ to
the fitting on the speedometer. Apply pressure
and compare the reading to the table below.
Re-connect line and test for proper operation.
Ride Plate
Impeller
Drive Shaft
Intake Grate
Speedometer Pick-up Fit
ting
Inspect Line for
Obstruction
3/00
6.22
Polaris Sales Inc.