Polaris Genesis 2000 - Page 224

ELECTRICAL
Specifications
Spark Plugs / Alternator
Refer to wiring diagrams in this section for more information
Alternate Spark Plugs:
For NGK BPR8ES. NGK BR9ES, or Champion RN2C
NOTE: Use only Resistor type spark plugs in all Polaris products
NOTE: Use only NGK PZFR6H spark plug in Genesis FFI™ .032" gap is critical!
CDI Box Identification
Refer to wiring diagrams in this section for more information and stator resistance specifica
tions.
*lgnition timing specification for high RPM - Check at specified RPM (5000-6250) not operating RPM.
Ignition Timing on Genesis FFI™ is set at the factory and is controlled by the EMM. Timing cannot be
changed or altered in any way on Genesis FFI™ personal watercraft.
When replacing a CDI box on a Virage TX, SLX, Pro 1200, or Genesis, it is very important
to check timing. A new CDI box may be programmed slightly different than the one be
ing replaced, causing ignition timing to be advanced or retarded too far.
Polaris Sales Inc.
7.1
3/00