42
FEATURES
Instrumentation
MFD Digital Display Programs
Performance Program
Clock Setting (if equipped)
1. Enter the Performance Program.
2. Press and release the SET button
until the clock screen is active.
3. Press and hold the SET button for
five seconds.
4. When the hour starts flashing,
press the SET switch once to advance one hour.
NOTE: Press and hold the SET button to advance the hours quickly.
5. Press and release the MODE button to save the hour. The minutes
will begin flashing.
6. Set the minutes in the same manner.
7. When finished, press and release the MODE button to save the new
setting.
NOTE: If the MODE button is not pressed within ten seconds, the gauge will
automatically save the new entry.
To Next Page
Loading...
