55
THE PERFECT FIT
IQ & Switchback Rear Suspension Adjustments
Initial Spring Preload Setting (Sag Method)
To determine sag, commonly referred to as ride-in, subtract measure-
ment Y from X (sag=X-Y). If the measured sag is incorrect, adjust the
FRA position and/or rear torsion spring preload.
NOTE: This is only an initial setup, and final spring preload may vary based on
rider preference and riding conditions.
Suspension Recommended Sag Adjustment
See
Page
IQ 121 4-5 inches (10-13 cm) Torsion Spring
Preload
56
Switchback
136
4-5 inches (10-13 cm) Torsion Spring
Preload
56
To Next Page
Loading...
