AXLE AND WHEEL NUTS
Do not service axle nuts that have a cotter pin
installed. Your Polaris dealer can assist.
LAMP LIGHT
REPLACEMENT
DAYTIME RUNNING LIGHTS (IF
EQUIPPED)
If the daytime running lights do not operate,
replace the lamps. It is recommended you install
replacement lamps obtained from your
authorized Polaris dealer.
1. Remove the front cover (OUTLAW only).
2. Disconnect the lights from the harness.
3. Remove the rubber cover from the back of the
light assembly.
4. Press the lamp retainer inward and turn it
counter-clockwise to remove it. Note position
of the lamp positioning tab, then carefully pull
the lamp out.
5. Install the new lamp. Make sure the filament
is horizontal.
6. Reinstall the lamp retainer. Press the retainer
inward and turn it clockwise about 1/4 turn.
7. Start the engine to make sure the lights come
on. If the lights do not operate, see your
POLARIS dealer for service.
8. Reinstall the rubber cover, and reconnect the
lights to the harness.
9. Reinstall the front cover (OUTLAW only).
144
MAINTENANCE
To Next Page
Loading...
