143
Maintenance
Daytime Running Lights Lamp Replacement
If the daytime running lights do not operate, replace the lamps. Polaris recommends that you
install replacement lamps obtained from your authorized Polaris dealer.
1. Disconnect the lights from the harness.
2. Remove the rubber cover from the back of the light assembly.
3. Press the lamp retainer inward and turn it counter-clockwise to remove it. Note the posi-
tion of the lamp positioning tab, then carefully pull the lamp out.
4. Install the new lamp. Make sure the filament is horizontal.
5. Reinstall the lamp retainer. Press the retainer inward and turn it clockwise about 1/4 turn.
6. Start the engine to make sure the lights come on. If the lights do not operate, see your
Polaris dealer for service.
7. Reinstall the rubber cover, and reconnect the lights to the harness.
To Next Page
Loading...
Need help?
General
